1JZ/2JZ MT Engine Harness for Maxxecu Gen 2 Track

1JZ/2JZ MT Engine Harness for Maxxecu Gen 2 Track!

Compatible in most front mount engine rear wheel drive vehicles, this Damanfer 1JZ/2JZ engine harness for Maxxecu Gen 2 Track meets the needs of most. Designed to go into cabin from intake manifold side of engine and have fuse and relay board on passenger glovebox.

Built with Mil-Spec ETFE Insulated Electric Wire (Tefzel wire) we strive to offer top quality harnesses.

Inputs:

1. TPS
2. Engine Coolant Temp. (ECT)
3. Oil Pressure
4. Fuel Pressure
5. Flex Fuel
6. AIT
7. Speed Input
8. Speed Input
9. 2 Step Switch
10. A/C Switch
11. Bosch Knock Sensor

Outputs besides Injectors and coils:

1. Boost Solenoid
2. A/C Compressor
3. Radiator Fan
4. Fuel Pump #1
5. Fuel Pump #2
6. RPM
7. Speed
8. Check Engine Light

Included with wiring harness is a fuse and relay box with 5 fuses and relays as fallows:

1. ECU
2. Injectors
3. Coils
4. A/C
5. Starter

Harness is set up to having to connect 12v switch, starter signal, A/C switch signal, battery ground, and outputs to stock relays for radiator fans and fuel pump (for ECU control).

That is all it takes to get you ready for tuning.

If you are using DBW setup, you can send us an email at DMF@DAMANFER.COM with details on throttle body and pedal that you will use and we can set harness for it at not additional charge.

Please select injectors and coils used on set up to have correct connectors on harness.